TTulpe low NOx gas water heaters


TTulpe®

TTulpe instantaneous water heaters for domestic and Leisure.

TTulpe Indoor B-6 Eco

TTulpe Indoor B-11 Eco

TTulpe Indoor B-14 Eco

TTulpe® Indoor B14 P37 Eco

The new TTulpe® Indoor B14 Eco The "Indoor B-14 Eco" gas water heater can be installed indoors and is a 14 liter per minute model. The Indoor B-14 Eco is an open modulating propane gas water heater. The self-modulating valve controls the amount of energy required to heat the water that is required. This ensures a considerable energy saving. There is also a gas saving mode so that less gas is used in the warmer months. Because of the modulation, this water heater is ideally suited in combination with mixer taps or thermostat taps. The gas water heater works from a water pressure of 0.2 bar. This is the lowest water pressure in the market. The Indoor B-14 is an open type gas gas water heater. The use of a fluepipe to the outside is necessary. Sufficient ventilation must also be taken into account in the room where the appliance is hung. By means of various safeguards, the water heater will switch off when the flue gases are insufficiently removed. The device is equipped with manual operation of the gas supply and the water flow. You can set the temperature by adjusting the water flow rate with the right rotary control. The automatic ignition works on a battery and starts operating as soon as water flows through the device. No power connection is therefore required. The automatic ignition ensures the ignition of a pilot flame. The pilot flame then ignites the main burner when you request hot water. If after 60 seconds there is no more hot water demand, the pilot light will extinguish. Once installed, you no longer have to worry about the device. Installing and installing the device is easy. The connections for water and gas are provided with ½ inch thread. The TTulpe® Indoor B-14 is suitable for replacing your old boiler, kitchen, bath or shower heater. but of course also as a new hot water supply in your boat, caravan, tiny house, apartment or holiday home. TTulpe Indoor B-14 P37 Eco - Gas type: propane - Gas pressure: 30-37 mbar - Rated output power: 24.3 KW - Battery ignition (1.5 Volt) - Frost protection: no - Dimensions: 363x650x247 mm - minimum water pressure: 0.2 Bar - Maximum water pressure: 10 Bar - Water flow: between 2.5 and 13.6 liters per minute - Temperature range: 35 to 65 degrees - Flue gas outlet connection: 130 mm - Net weight: 14 Kg. - Energy class A - Tap water: L (similar to CW4) - Electric frost protection system: No. -KIWA, Gastec certified Package contents: geyser, manual, 1x 1.5 Volt battery type LR20, strainer.

TTulpe® Indoor B11 P37 Eco

The new TTulpe® Indoor B11 Eco The "Indoor B-11 Eco" gas water heater can be installed indoors and is an 11 liter per minute model. The Indoor B-11 Eco is an open modulating propane gas water heater. The self-modulating valve controls the amount of energy required to heat the water that is required. This ensures a considerable energy saving. There is also a gas saving mode so that less gas is used in the warmer months. Because of the modulation, this water heater is ideally suited in combination with mixer taps or thermostat taps. The gas water heater works from a water pressure of 0.2 bar. This is the lowest water pressure in the market. The Indoor B-11 is an open type gas water heater. The use of a flue pipe to the outside is necessary. Sufficient ventilation must also be taken into account in the room where the appliance is hung. By means of various safeguards, the gas water heater will switch off when the flue gases are insufficiently removed. The device is equipped with manual operation of the gas supply and the water flow. You can set the temperature by adjusting the water flow rate with the right rotary control. The automatic ignition works on a battery and starts operating as soon as water flows through the device. No power connection is therefore required. The automatic ignition ensures the ignition of a pilot flame. The pilot flame then ignites the main burner when you request hot water. If after 60 seconds there is no more hot water demand, the pilot light will extinguish. Once installed, you no longer have to worry about the device. Installing and installing the device is easy. The connections for water and gas are provided with ½ inch thread. The TTulpe® Indoor B-11 is suitable for replacing your old boiler, kitchen, bath or shower heater. but of course also as a new hot water supply in your boat, caravan, tiny house, apartment or holiday home. TTulpe Indoor B-11 P37 Eco - Gas type: propane, butane or LPG - Gas pressure: 30-37 mbar - Nominal output power: 19.3 KW - Battery ignition (1.5 Volt) - Frost protection: no - Dimensions: 314x592x246 mm - minimum water pressure: 0.2 Bar - Maximum water pressure: 10 Bar - Water flow: between 2.5 and 11 liters per minute - Temperature range: 35 to 65 degrees - Flue gas outlet connection: 110 mm - Net weight: 12 Kg. - Energy class A - Tap water: M (similar to CW3) - Electric frost protection system: No. - KIWA, Gastec certified Package contents: geyser, manual, 1x 1.5 Volt battery type LR20, strainer.

TTulpe® is a Dutch quality brand for high tech water heaters.
Our passion to improve water heaters resulted in modern, safe, environment friendly and affordable water heaters.
Over 30 years of experience with water heating solutions, German engineering, a modern and sustainable production plant and the highest level of customer care is what TTulpe® separates us from the rest.

ErP / NOx Ready
With the adoption of the Kyoto protocol, the European Union has committed itself to reducing CO2 emissions by at least 20% by 2020, the so-called "20-20-20 target". This means a 20% reduction in CO2 emissions, a 20% increase in energy efficiency and a 20% increase in the share of reusable energy.
The ErP directive (Energy-related Products) was signed in 2009. This is often simply referred to as the ecodesign directive.
This guideline has been introduced in phases since 26 September 2015. Ecodesign sets mandatory ecological requirements for all energy-using and energy-related products sold in all Member States. More than 40 product groups (boilers, lamps, TVs, refrigerators, etc.) are defined within this guideline
Since September 26, 2018, the rules of the game are stricter again for new gas water heaters coming onto the market. The standard for nitrogen oxide emissions (so-called NOx) is then stricter. From this date, all gas-fired appliances must comply with a maximum NOx emission of 56 mg / kWh. As a result, there will still be few or no "B1 gas water heaters" for sale that meet those stricter requirements. Stricter standards also apply to spare parts, making repairs more difficult. This means that older equipment is replaced faster because they can no longer be repaired.
TTulpe cares about the environment, our gas water heaters do not contain any hazardous materials and meet the limits set by RoHS 2 directive (EU) 2015/863 with supplement to Annex II to directive 2011/65 / EU.
The TTulpe Indoor B-6, 11 and 14 Eco complies with the Ecodesign guideline 2009/125 / EC and has extremely low NOx emissions. (mandatory for all devices after September 2018).

We are proud to present our new range of gas water heaters!

TTulpe B.V.

Wester Boekelweg 21a

1718MJ Hoogwoud

Nederland